WEEE shredding is part of a treatment chain that combines preparation, reduction and separation. Electronic waste can contain very different materials in the same load. To select blades and spare parts, it is advisable to start by defining what fraction is authorized to enter the machine and how it has been prepared.
Preparation conditions the cut
Batteries, components to be removed and substances that require specific management must be resolved within the facility’s treatment procedure. The grinder should not be used as a substitute for this preparation. Document the admitted flow, its origin, and previous operations. Applicable legal and safety requirements must be reviewed for each facility and type of waste.
Reduce size to facilitate separation
In a recovery process, the output size must favor the later stages. Cutting too much can create a thin mixture that is difficult to separate; insufficient reduction can leave bonded materials. The configuration must be verified by representative tests. WEEE equipment cannot be selected only by power: the power supply, the cutting system and the planned separation also count.
Record incidents in a useful way
Note date, estimated composition, load, alarms and observed damage. Locate the affected blades and retain photographs of the material that caused the issue when this can be done safely. This information helps differentiate normal wear from improper input. The history must make it possible to relate recovered production and frequency of intervention.
Define spare parts with maintenance
Check discs or blades, separators, supports and fixings depending on the model. Do not extrapolate a reference between shredders of the same brand. Provide serial number, drawing and axle configuration. ELDAN presents equipment for electrical and electronic waste among its solutions; suitability for a specific flow requires technical consultation and testing, without attributing performance to a generic machine.
Frequently asked question
Can any mixed appliance be shredded?
Admission depends on preparation and authorized process. The treatment of batteries and other components requires specific procedures before feeding the reduction.
Documentation and related reading
Technical reference: ELDAN: recycling solutions and equipment. The practical observations in this guide must be compared with the documentation of the installed equipment.
Expand information with our related technical guide and consult the Sharp industrial spare parts.
Consult a blade or spare part
Send us your query with brand, model, reference and photographs to study the piece and prepare a quote. For tools in service, also see tool options. sharpening and repair.